Tap Replacement in Kettering
Hard water is brutal on Kettering taps — constant limescale stiffens handles, furs up spouts, and wears out washers far quicker than in soft-water areas. They start dripping, and eventually they're wasting water and costing you money. A single dripping tap can waste over 5,000 litres a year — that's showing up on your water bill whether you notice it or not.
Across Kettering every kind of tap gets swapped — kitchen and bathroom, monobloc and deck-mounted, wall-mounted and pull-out spray. If you've bought a tap yourself, your plumber will fit it. If you'd rather it was supplied for you, your plumber will recommend something that suits your setup, your water pressure, and your budget. Clean swap with no mess left behind.
We cover the town centre, Northall, Barton Seagrave, Brambleside, and the surrounding villages. When a tap is replaced, the isolation valves underneath are checked and swapped if they're seized or weeping — so you can actually turn off individual taps in future without shutting off the whole house. The flexi-hoses are replaced at the same time if they're old or corroded. No point fitting a new tap on dodgy connections.
The tap calls we get most around Kettering are the slow-drip kitchen monobloc that's finally given up after years of fighting the limescale, the bathroom basin tap that's stiff because the cartridge has scaled solid, and the bath filler that won't shut off properly. All three are usually fixable with the right brass-bodied replacement and a fresh set of isolation valves. Your plumber stocks the brands they trust and won't fit the throwaway models that fail again within two years.
