Wet Room Installation in Burwell
Burwell sits where the chalk meets the fen below Devils Dyke, and that mix of chalk upland and low fen gives the village two very different sets of ground. Wet rooms have gone from a luxury feature to one of the most requested bathroom upgrades. The appeal is obvious — a clean, open shower space with no tray or curtain, easy to clean, and a look that makes even a small bathroom feel twice the size. They're also the most practical solution for anyone with mobility concerns, removing the step-over that makes a traditional shower or bath difficult.
The village runs on hard chalk water, so limescale in cylinders, valves and shower fittings is behind a lot of the work here. The properties across Burwell suit wet rooms in different ways. The older homes in North Street and the town centre often have ground-floor bathrooms with solid floors — ideal for cutting a gradient and installing a linear drain. The newer builds on the Causeway work well for en-suite wet rooms, where the compact space benefits from the open design. Wet rooms also work well in loft conversions, extensions, and garage conversions where the bathroom is being built from scratch.
Many of the older cottages are built of clunch, the local soft chalk, and their pipework has been layered up over generations of alterations. The difference between a wet room that works and one that causes problems comes down to the tanking. A full liquid membrane system waterproofs the entire floor and walls to at least 1.2 metres. Every corner joint, pipe penetration, and floor-to-wall junction gets sealed with reinforcing tape and additional membrane coats. Done properly, with no corners cut, a tanked wet room is as watertight as a swimming pool.
